Omlet server

[Tombull10]

Hi guys,

 

I have bought an eglu and run second hand. I'm just trying to assemble it all and it's proving difficult to put together. When clipping together the sections of the run should they overlap or butt up to each other? Also, when screwing the run to the eglu, should the screw and washer go through the 'half sized hole' in the run mesh or just anywhere that fits? I know this probably all seems a stupid question but any help, advice or tips would be greatly appreciated as I don't want this to take longer than neccessary on such a cold day!!

 

Thanks

[Redwing]

the peices should butt up together, nothing overlaps apart from the two little squares of run that go partly under the Eglu

 

I put the nuts and bolts through the little bits of run mesh but as long as it all goes together I guess it doesnt really matter

[Ain't Nobody Here]

Yup, I agree with Tasha . I've had to put one of the screws/bolts through the "normal" bit of the run after taking it apart 'cos I just couldn't get it to fit otherwise. So as long as they're in somewhere it doesn't matter too much.

[poachedegg]

Sounds like you're having fun!

[Ain't Nobody Here]

I did find the instructions online somewhere if you've got stuck . I'm assuming you're out there building it right now!

[Madbird]

Instructions... good luck!

 

http://www.omlet.co.uk/club/library/library.php?view=Library&cat=Chickens&sub=Eglu