MamaCoop Posted March 22, 2021 Share Posted March 22, 2021 (edited) 5 hours ago, superjules said: Does anyone know whether a mark 1 cube + 3m run will fit into a BMW X3 with the back seats down pls? Hi would depend if all in parts or whether partly or fully built? I collected a Mk1 cube and had 1m of its run attached. We could disconnect that bit of the run...it also had another 2m of run with it too. Cube only fit ....just width wise (they are big!) And even with seats pushed forward struggled to fit all the run that was in bits I had a VW Caravelle same as a T5 VW Van. BUt with two seats in the back on rails. Not sure about your specific car? In the end I had to take out my two back seats and pile them on top of each other for the Cube and run. And it was a squeeze. I couldn't believe how big the cube was! Worth asking if in parts....that would be easier but if not measure the width and height of your car. Edited March 22, 2021 by MamaCoop Quote Link to comment Share on other sites More sharing options...
MamaCoop Posted March 22, 2021 Share Posted March 22, 2021 (edited) 6 minutes ago, MamaCoop said: Hi would depend if all in parts or whether partly or fully built? I collected a Mk1 cube and had 1m of its run attached. We could disconnect that bit of the run...it also had another 2m of run with it too. Cube only fit ....just width wise (they are big!) And even with seats pushed forward struggled to fit all the run that was in bits I had a VW Caravelle same as a T5 VW Van. BUt with two seats in the back on rails. Not sure about your specific car? In the end I had to take out my two back seats and pile them on top of each other for the Cube and run. And it was a squeeze. I couldn't believe how big the cube was! Worth asking if in parts....that would be easier but if not measure the width and height of your car. I meant to say couldn't disconnect. If it was fully built I wouldn't have got it in. As it was I scratched along the insides sliding it in. Here is a pic...so all in all a Mk1 Cube and 3m of run. It was tight Edited March 22, 2021 by MamaCoop Quote Link to comment Share on other sites More sharing options...
Patricia W Posted March 22, 2021 Share Posted March 22, 2021 The Mk1 cube and run fits in my 2009 Citroen Picasso with the back seats out. That’s why I hold on to it! Quote Link to comment Share on other sites More sharing options...
superjules Posted April 6, 2021 Share Posted April 6, 2021 I fitted a cube and 4m of run in my 2009 BMW X3 (with the back seats down obvs!) Quote Link to comment Share on other sites More sharing options...
Cat tails Posted April 14, 2021 Share Posted April 14, 2021 Well done! That’s some serious packing! Quote Link to comment Share on other sites More sharing options...