Jump to content
Leicester_H

Since Omleteers know everything ......

Recommended Posts

Hi

My local sports centre has been refurbished.

In the wash rooms, the hot air hand dryers are now much lower than before.

This means that most people (inc myself 5'3" tall) have to bend at a very unnatural / awkward angle to use them - just the sort of angle that gives back ache - 'everyone' is complaining.

The result of filling out a comment form was that they are installed to the industry standard height.

A quick google revealed some (conflicting) rules for accessible toilets.

 

Anyone know anything ?

 

I'm all in favour of assisting wheelchair users etc. but I don't see why the majority should 'suffer' - the simplest solution would be to have 2 dryers (they can't cost that much - the whole refurbishment is costing £3.5M (I think!!)) - or is that against the rules / discriminatory ?

 

Or an I just getting grumpy ?!

 

H

Link to comment
Share on other sites

Just had our cloakrooms refurbed at work, & ours have been put in at a decent height.

If anyone one would bow to an industry standard, I suspect my employers would :roll:

 

I wonder if they have got mixed up with the ones that you put your hand in from the top...Dyson Airblade is it???

They would obviously have to be lower.

Link to comment
Share on other sites

Don't know the answer to that, sorry!

 

My leisure centre has put the holder for the new floor mats so high up that unless you're 5' 10" or above, you have to stand on tiptoe and even then it's really hard to take off/put back the mats :evil: .

 

I'm trying a one-woman protest by leaving my mat on the floor (where the old mats used to live). "Ooops, word censored!"ody seems to have noticed yet :wall: . And yes, I have complained in writing!

Link to comment
Share on other sites

Seems sensible that they have one that is accesible for wheelchair users and one for non....could you check with your local council as to the exact rules?

 

Equally you could try mentioning to the leisure centre that this lowering of hand dryers is causing you discomfort and will surely do the same to other users and see what they say?

 

Do keep us updated....its an interesting thread :think:

Link to comment
Share on other sites

shows hand driers at a height of 800mm - 1000mm from floor level to the under side of the drier

 

800mm sounds about right.

There is only ONE drier - as its a complete refurbishment, I doubt they'll install another.

I did complain at reception and they agreed with me.

Hence completed their feedback system - and response as above.

 

Thanks for your replies - always useful to know if others agree or not.

 

H

Link to comment
Share on other sites

They recently done a similar thing with the pay machines in Reading Station's main car park. You have to almost get on your knees now to use them! There's 3 machines, they could have perhaps just lowered one.

 

daft question but why do they need wheel chair height ticket machines in a car park don't wheel chair users qualify for blue badges and as such get free parking ?

Link to comment
Share on other sites

Not always it depends who owns the car park :roll: The one at Ninewells hospital in Dundee is privately owned and blue badges have to pay as well :twisted:

 

My late father let my mums badge expire so when I took her in to see him I had to unload her and the chair abandon her go away to park walk back and do the whole thing in reverse as they were so inflexible :roll: On the one occasion I dared to use the expired badge I got a parking ticket even though they must have watched me get mum out of the car from their office as it was slapped on less than 2 minutes after the arrival time on the parking meter ticket :evil::evil:

Link to comment
Share on other sites

Provision should be made for disabled use; but, in many cases, it's done blindly withouth any though given to the consequences for others. OH is 6ft 5in (I'm 5ft 2in). Seeing him using ATMs, car park and cinema ticket machines, till points, hand driers, etc, you can see why he suffers from a bad back all the time. There seems to be an automatic assumption that tall people can bend down to use this equipment and this isn't always the case. Even if you do bend down, the angle of the displays often make them hard to read.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...