Jump to content
Snowy

Ebay bargain - updated with new pics page 2!

Recommended Posts

Been faffing about for a few years now, replacing the plastic garden furniture every other year and pining for a nice wooden patio table. Anyway, I managed to bag this beauty today for £70. It's very solid but is desperate for some TLC. Anyone able to advise me about wood? I've already used up an existing bottle of teak oil. I'll see how it soaks in and whether or not it deepens the colour of the wood. If not, I'm thinking of some coloured wood oil? What do you think? Or should I just have varnished it? The wood is very dry.

DSCF2535.jpg

You can see where I've oiled already:

DSCF2534.jpg

DSCF2531.jpg

There are also 4 reclining chairs with cushions 8)

DSCF2533.jpg

The lazy susan needs a new mechanism, anyone know if these can be bought seperately? (not that I'm too bothered)

DSCF2530.jpg

 

Oh yes, and it has two extension leaves underneath that swing into place at the flick of a couple of catches :D (although it would probably be bigger than the patio then :lol: )

 

I'm delighted with it, even if I can't improve the look of the wood much. I'm sure it will last much longer than a new plastic set would! But any advice on improving the wood would be gratefully received! 8)

Edited by Guest
Link to comment
Share on other sites

That's fab, I have wooden furniture that had seen better days, it was awful as it's left out uncovered all year round so it was grey in most places & green in others :oops: So last year I used a cleaner that I think was made by Cuprinol, it was in tin similar to a paint one. I painted the stuff on with a brush, scrubbed it in and rinsed it off, and re-oiled it when it had dried, and the colour was restored and even, my furniture looked brand new again! :D I can't remember if I used Teak oil or danish oil but once I'd used the cleaner the natural colour of the wood reappeared from under the grime & it was beautiful.

 

If only I'd got another coat or two of oil on I wouldn't have to do it again this year :doh:

Link to comment
Share on other sites

Persevere with the teak oil snowy if you start to use stain or varnish you will first have to remove the oil and then it will start to flake so will need sanding each time you have to reapply :evil:

 

It is so dry it may need a few coats of oil but you will get to a nice colour eventually and when you need to redo it all you have to do is wash any grime off with soapy water or a blast with a powerhose 8)

Link to comment
Share on other sites

Lovely, thanks for all your advice! You confirmed what I was thinking, that oil would be the best route to take. I've been out and invested in some cuprinol garden furniture restorer for the table surface as that is the worst bit, and a large tin of cuprinol teak oil. It was the same price as the homebase own stuff!! :shock:8) Will let you know how it goes :D

Link to comment
Share on other sites

Quick update: I've used the cuprinol restorer to strip off the top layer and given it a good sanding, then two coats (so far) of cuprinol teak oil. Am delighted with the results! 8)

DSCF2537.jpg

 

DSCF2536.jpg

 

I didn't realise until I'd run out of oil that I'd forgotten to do the lazy susan, so that still needs doing! I also tried it out extended and the two extra leaves underneath work perfectly :D

Link to comment
Share on other sites

Any garden furniture oil are ok,but the best method of applying them is with wire wool.Pour the oil into a container,dunk the wire wool in and start rubbing the table.Allow it to soak in as much as it can then repeat twice more.The colour will deepen the more coats you apply.

 

Oil makes the timber grain lift and the wire wool simply smoothes is over.After 3 good coats-wipe excess off with clean rag and enjoy! :D

Link to comment
Share on other sites

Any garden furniture oil are ok,but the best method of applying them is with wire wool.Pour the oil into a container,dunk the wire wool in and start rubbing the table.Allow it to soak in as much as it can then repeat twice more.The colour will deepen the more coats you apply.

 

Oil makes the timber grain lift and the wire wool simply smoothes is over.After 3 good coats-wipe excess off with clean rag and enjoy! :D

 

Thanks Stevie, I've got some wire wool so will use that and give it a couple more coats to really seal and finish it 8)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...